Apg MLS Movable Float user manual Manuale Utente Scaricare il pdf (Pagina 6)

MLS Series Rev. B1, 4/07

Automation Products Group, Inc.

APG...Providing tailored solutions for measurement applications

Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]

• Installation

Unpacking

The MLS Series has been thoroughly inspected and carefully packed at the

factory to prevent damage during shipment. When unpacking, exercise due

care not to subject the instrument to mechanical shock. After unpacking,

visually check the instrument exterior for damage.

Note the following points:

• Do not bend and pull the shaft extremely during installation.

• Make sure that the  oat type level switch is according to ordering

speci cations.

• Protector of metal made is put between tip of shaft and microswitch to

avoid mechanical shock during shipment. Remove the protector certainly

before using.

Installation Location

This switch should be installed in an area where the following conditions:

• Provide ample space for maintenance/inspection.

• Low relative humidity and no exposure to moisture.

• No corrosive gases (such as NH

, SO

, Cl

and so on.)

• No excessive vibration

Assembly

Usually, the MLS is set to speci ed measuring length before shipment.

When not speci ed, each parts are packed severally. In that case, proceed to

assemble as follows.

1 2 3 4 5 6 7 8 9 10 11 12

Nessun commento

Apg MLS Movable Float user manual Manuale Utente Pagina 6